Physics lab series and parallel circuits

Name Date Class Lab 32: Series and Parallel Circuits Purpose To build series and parallel circuits and study the differences between them Background Electricians are called upon whenever new buildings need electrical work. The electrician surveys the site and determines what kind of currents and voltages are required to satisfy the client’s needs. Sometimes the circuit requires components to be connected like you would in plumbing so the water could flow. This is called a series circuit. Sometimes the components need to be connected in parallel, like the rungs on a ladder. Each type of circuit has its advantages. In this lab, you will study the advantages of and the differences between series and parallel circuits. Skills Focus Classifying, inferring, comparing and contrasting, drawing conclusions Procedure 1. Start Virtual Physics and select Series and Parallel Circuits from the list of assignments. The lab will open in the Circuits laboratory. Series and Parallel Circuits 3. You need to build a circuit that has only one path for the current to follow. This is called a series circuit. Use only resistors to make this circuit. On the engineering paper, place five resistors in series using the resistor symbol at the top. First start by connecting the first resistor to an open end of the function generator. Then drag out a new resistor and place it next to the open end of the last placed resistor. Follow the same process until you have five resistors in series. Complete the circuit by connecting the last resistor you added to the other side of the voltage source. 4. Make sure that that there is only one path for the current to flow through the resistors you connected in Step 3. After you have placed the resistors on the circuit, you will need to change the resistance of each of the resistors as specified in Step 5. You can do this by clicking on the number next to the resistor. A small box will pop up where you can adjust the value of the resistor. 102 Series and Parallel Circuits Virtual Physics Lab Workbook, by Brian F. Woodfield, Steven Haderlie, Heather J. McKnight, and Bradley D. Moser. Published by Pearson Learning Solutions. Copyright © 2008 by Pearson Education, Inc. ISBN 1-269-73240-4 Series and Parallel Circuits 2. The laboratory will be set up with a function generator set to 12 V DC already on the engineering paper, which is the schematic or plan of the circuit built on the breadboard. In this assignment, you will have to add resistors to create a circuit. To add resistors, simply click on the resistor symbol at the top of the engineering paper and drag it onto the paper. You may move resistors around by clicking them on the middle blue dot. You can also extend their leads by clicking on the end red dots and dragging them to where you want to connect them to other components. The line will be green if it is in an allowable location. You will notice that the breadboard will automatically populate with the resistors that you add to the schematic. Name Date Class 5. Change the value of each resistor to the match the values found in Data Table 1. Assume that resistor 1 is the one connected to the positive side of the voltage source and resistor 5 is the one connected to the negative side of the voltage source. Data Table 1 Resistor Number Resistor Value ( 1 120 2 500 3 200 4 135 5 10,000 ) 6. Using the multimeter to measure the current and the voltages across each resistor.